There are several applications that require an uninterruptible power supply (UPS). One example is RAID systems for redundant data storage, which must be protected to prevent data loss in the event of a power failure at an inopportune moment, such as during a data backup. Systems with real-time clocks also require continuous power, which can come from a battery or another backup solution. Other applications include telemetry in the automotive industry and medication delivery systems, such as insulin pumps used in healthcare.
Figure 1. Typical application of an uninterruptible power supply.
Figure 1 shows a typical industrial application of an uninterruptible power supply (UPS) system. In this case, power is supplied to an industrial sensor. The system's reliability depends primarily on the sensor's power supply. A linear charge regulator integrated circuit is used to charge a supercapacitor when system voltage is available. If the system voltage drops, the energy from the electrical storage system is boosted to the required supply voltage level using a boost regulator. This system works well, but it is difficult to implement because it requires many different power converters. Furthermore, in many applications, it is important that no energy flows from the electrical storage system back to the power supply (Figure 1). As shown in Figure 1, the supercapacitor should only power the sensor circuit and not any other electronic components that might be connected to the 24 V line (shown on the left of Figure 1). The electrical storage system is typically designed to power the local load, not the entire system connected to the 24 V supply voltage. This necessitates the diode D in Figure 1.
Figure 2. The Continuous backup concept with numerous integrated system functions.
Figure 2 illustrates a new concept supported by the Analog Devices MAX38889. This is a highly integrated backup solution called Continua™ for power lines up to 5 V. A single IC with a few external passive components is all that is required. The MAX38889 has an integrated half-bridge, operating alternately in high-efficiency buck and boost modes.
Figure 3 shows an implementation of a tiny Continua backup solution using an ADI MAX38889.
Figure 3 shows a complete, operational circuit. The logic and power switches are all integrated, so only a small external chip-scale inductor and a few backup capacitors are needed, apart from the supercapacitor.
The integrated high-side (Hs) power switch operates using ADI's True Shutdown™ technology. As a result, the system voltage can be separated from the capacitor voltage, so no current flows from the capacitor to the system if the capacitor voltage rises.
While many backup solutions exist on the market for various voltage and current ranges, the MAX38889 Continuous is a unique backup solution with a compact design that can be easily added to a 5V or 3.3V power line with minimal development and implementation effort. This solution also has a high conversion efficiency of up to 94% in both charge and discharge modes to minimize the size and cost of the energy storage.
About the author:
Frederik Dostal is an energy management expert with over 20 years of experience in the field. After studying microelectronics at the University of Erlangen, Germany, he joined National Semiconductor in 2001, where he worked as a field applications engineer, gaining extensive experience implementing power management solutions in customer projects. During his time at National, he also spent four years in Phoenix, Arizona (USA), working on switched-mode power supplies as an applications engineer. In 2009, he joined Analog Devices, where he has held various positions working on the product line and European technical support, and currently contributes his broad knowledge of design and applications as a power management expert. Frederik is based at ADI's office in Munich, Germany.
