The new material offers a higher temperature limit than most conductive fluorosilicones (up to 200°C in continuous use) and is resistant to aggressive chemicals such as machining coolant, hydraulic fluids, mineral oils and various fuels.
With a hardness of only 45 Shore A (35% softer than CHO-SEAL® 1298), the low compressive strength of CHO-SEAL® 1299 makes it ideal for EMI shielding applications, including military communications modules, unmanned aerial vehicles (UAVs), naval and onboard electronics, wearable electronics, and robotics equipment. Providing protection against the ingress of dust, moisture, and more, the new RoHS-compliant material is innovative for diverse electronic device applications that require design flexibility without compromising EMI shielding effectiveness.
A common use case is connector interface gaskets. In smaller connectors, compressing a conductive elastomer material, even in small quantities, can be difficult due to the high power requirements. Access to a softer material will benefit customers who have encountered a similar challenge.
As an electrically conductive fluorosilicone elastomer, CHO-SEAL® 1299 provides excellent EMI shielding across a broad frequency spectrum. For example, according to test method MIL-DTL-83528 (section 4.5.12), the new EMI gasket material provides a minimum shielding effectiveness of: 128 dB at 100 MHz (E-field); 102 dB at 500 MHz (E-field); 110 dB at 2 GHz (planar wave); 122 dB at 10 GHz (planar wave); and 94 dB at 18 GHz (planar wave).
While the legacy version offers 60% elongation, CHO-SEAL® 1299 can provide 100% according to the ASTM D412 test method. This superior elongation provides greater flexibility and ductility, allowing the new material to conform to irregular surfaces and resist deformation without fracturing. This capability is critical for maintaining effective EMI sealing and shielding and facilitates gasket installation.
CHO-SEAL® 1299 is available in molded formats, including O-rings, D-rings, and custom gaskets. Parker Chomerics also offers the new material in sheet form for cut gaskets. The sheets can be die-cut using a steel rule, XY knife, or waterjet (non-abrasive) to manufacture precision parts in large quantities. If required, the sheets can be supplied with an electrically conductive pressure-sensitive acrylic (PSA) adhesive to facilitate the assembly process. In addition, CHO-SEAL® 1299 will soon be available in extruded profiles.
