The ADIN1300 integrates the Ethernet MAC controller and the physical layer (PHY) into a single circuit compliant with the IEEE 802.3cg standard, enabling data and power transmission over a single copper pair at distances of up to 1,000 meters. This architecture significantly simplifies system design and reduces cabling, installation, and maintenance costs compared to traditional Ethernet solutions.
Designed for industrial environments, the ADIN1300 offers high noise immunity, robustness against electromagnetic interference, and compatibility with advanced network topologies. It is ideal for applications such as smart sensors, process instrumentation, factory automation, energy infrastructure, and smart buildings, where reliable Ethernet connectivity is required in remote locations.
Key technical features include:
- Full compliance with IEEE 802.3cg 10BASE-T1L
- Range of up to 1 km over single twisted-pair cable
- High-performance SPI interface for efficient connection with microcontrollers and embedded processors
- Support for full-duplex and low latency
- Advanced link monitoring and diagnostic functions
- Wide temperature range for industrial environments
The ADIN1300 is part of Analog Devices' Ethernet to the Edge ecosystem, facilitating the transition to architectures based on industrial Ethernet and enabling technologies such as Ethernet-APL and IIoT (Industrial Internet of Things).
The ADIN1300 is available in a 6 mm × 6 mm, 40-lead, full-scale chip package (LFCSP). The device operates with a minimum of two power supplies: 0.9 V and 3.3 V, assuming a 3.3 V MAC interface power supply is used. For maximum system-level design flexibility, a separate VDDIO power supply allows the MAC interface and management data input/output (MDIO) power supply voltages to be configured independently of the rest of the ADIN1300 circuitry, enabling operation at 1.8 V, 2.5 V, or 3.3 V.
Upon power-up, the ADIN1300 remains in hardware reset until each power supply has exceeded its minimum rise threshold value. Protection against undervoltage is provided by monitoring the power supplies to detect if one or more of them drop below a minimum fall threshold (see Table 19 in the data sheet) and maintaining the device in hardware reset until the power supplies recover and satisfy the power-on reset (POR) circuit.
The MII management interface (also called the MDIO interface) provides a 2-wire serial interface between a host processor or MAC (also known as a management station (STA)) and the ADIN1300, allowing access to control and status information in the PHY core management registers. The interface is compatible with the management frame structures of clauses 22 and 45 of the IEEE 802.3 standard.
The ADIN1300 can support cable lengths of up to 150 meters at Gigabit speeds and 180 meters when operating at 100 Mbps or 10 Mbps.
Applications:
Industrial automation,
Process control,
Factory automation,
Robotics/motion control,
Time-sensitive networks (TSN),
Building automation,
Testing and measurement,
Industrial Internet of Things (IoT)
